Renault Clio: Choosing a child seat mounting
Renault Clio IV (2014-2019) Owners Manual / Getting to know your vehicle / Child safety / Choosing a child seat mounting
Rear-facing child seats
A baby’s head is, proportionally, heavier than that of an adult and its neck is very fragile. Transport the child in this position for as long as possible (until the age of 2 at the very least). It supports both the head and the neck.
Choose a bucket type seat for best side protection and change it as soon as the child’s head is higher than the shell.
Forward-facing child seats
The child’s head and abdomen need to be protected as a priority. A forward-facing child seat which is firmly attached to the vehicle will reduce the risk of impact to the head. Ensure your child travels in a forward-facing seat with a harness for as long as their size permits.
Choose a bucket type seat for optimum side protection.
Booster cushions
From 15 kg or 4 years, the child can travel using a booster seat, which will enable the seat belt to be adapted to suit his/her size and shape. The booster seat cushion must be fitted with guides to position the seat belt on the child’s thighs rather than the stomach.
It is recommended that you use a seatback fitted with a belt strap guide which can be adjusted in terms of height to position the seat belt in the centre of the shoulder. It must never rest on the neck or on the arm.
Choose a bucket type seat for optimum side protection.
READ NEXT:
Choosing a child/baby seat mounting
There are two ways of attaching child
seats: via the seat belt or using the
ISOFIX system.
Attachment via the seat belt
The seat belt must be adjusted to
ensure that it is effective in the event
Fitting a child seat, general information
Some seats are not suitable for fitting
child seats. The diagram on the following
page shows you how to attach a
child seat.
The types of child seat indicated may
not be available. Before using
SEE MORE:
Fuel vapour recirculation circuit: Function
D4F or F4R or K4J or K4M or M4R
WARNING
The breather must not be blocked during normal
engine operation.
The tank is vented through the fuel vapour absorber.
Fuel vapour is trapped by the active carbon contained
in the absorber as it passes through.
Fuel vapour trapped in the absorber is eliminate
K9K, and JH3 or JR5 - K9K, and 772, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
During this operation, secure the vehicle to the
lift with a safety strap(s), to prevent it from
becoming unbalanced.
To fit the strap
