Renault Clio: High pressure pipe: Check
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Diesel Injection / High pressure pipe: Check
K9K
WARNING
After any operation, check that there are no diesel fuel leaks
- Reprime the diesel circuit using the priming pump.
- Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
- Remove the engine protector.
- Disconnect the inlet air pressure sensor (1)
- Remove the upper section (2) of the turbocharging duct.
- Loosen the clip (3).
- Move the inlet duct to one side (4).
- Unclip the clips (5) from the injector rail protector cover.
- Remove the mounting (6) from the injector rail protector cover.
- Remove the injector rail protector cover (7).
- Refit the inlet duct.
- Loosen the mounting nut of the air pipe at the intercooler inlet on the alternator.
- Fit the air duct between the turbocharger and the intercooler air inlet pipe.
- Snap the air duct to the turbocharger and to the air pipe at the intercooler inlet.
- Tighten the bolt of the air duct on the rocker cover.
- Torque tighten the nut mounting the intercooler air inlet pipe on the alternator (8 Nm).
- Connect:
- the inlet air pressure sensor.
- the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
Note: The Diagnostic tool can be used for testing the high pressure circuit with the engine running.
This command can be used to run fault finding
on a leak due to an incorrectly fitted or tightened
union. This command only works if the engine
coolant temperature is above 60READ NEXT:
K9K, and 750 or 752 or 760 or 762 or 766 or 768
Note:
Vehicles equipped with the K9K*768 engine may or
may not be equipped with an intercooler.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the
Accelerometer: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Disconnect the battery (see Battery: Removal - Refi
Crankshaft position sensor: Removal - Refitting
SEE MORE:
PIPE ASSEMBLY
D4F, and 740 or 742 or 764
(ZC1) cutting area between the catalytic
converter and the expansion
chamber
(ZC2) cutting area between the expansion
chamber and the silencer
D4F, and 784 or 786
(ZC1) cutting area between the expansion
chamber and the silencer
K4J
(ZC1) cutting area betw
Exhaust: List and location of components
Fuel consumption is accredited in accordance
with a standard regulatory
method. Identical for all manufacturers,
this enables vehicles to be compared
with one another. Consumption
in real time depends on vehicle usage
conditions, the equipment fitted and the
user’s driving style. To optimis
Eco-driving
