Renault Clio: Display A

Renault Clio. Display A


To access display 1 for setting the time, press button 2 or 3. Wait for a few seconds.

The hours and minutes flash and you are now in setting mode; press and hold button 2 or 3 to set the hours.

Once the minutes flash, repeatedly press or press and hold button 2 ou 3 to set the time.

Renault Clio. Display A


Then press and hold button 2 or 3 to confirm the time set.

The minute display flashes: repeatedly press or press and hold button 2 or 3 to set the time.

When setting is complete, the hours and minutes remain displayed continuously for 2 seconds: your setting is registered.

You may change the display.

Renault Clio. Display A


If the power supply is cut (battery disconnected, supply wire cut, etc.), the clock must be reset.

We recommend that you do not adjust these settings while driving.

READ NEXT:

 Display B

Vehicles fitted with touch-screen multimedia, navigation aid systems, telephones, etc. Refer to the separate instructions for the function to understand the special features of this equipme

 Rear view mirrors

Door mirrors with electrical adjustment With the ignition on, turn button 1: position C to adjust the left-hand door mirror; position E to adjust the right-hand door mirror; D is the

 Exterior lighting and signals

Side lights Turn the ring 2 until the symbol is opposite mark 3. An indicator light on the instrument panel will come on. Daytime running lights function (front lights only) Dependin

SEE MORE:

 High pressure pump: Removal - Refitting

K9K, and 764 or 772 WARNING Before starting work on the vehicle, obtain: a new plug kit (PART NO. 77 01 476 857), cleaning cloths (PART NO. 77 11 211 707), cleaning product (PART NO. 77 11 224 188). WARNING Parts always to be replaced: the high pressure pipe between the injector rail and th

 Sequential gearbox engine speed sensor: Removal - Refitting

D4F, and JA3 REMOVAL I - REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Discharge pressure accumulator " AC081. To confirm the pressure drop, read the " Hydr

© 2016-2025 Copyright Renault Clio Owners Club