Renault Clio: Right-hand drive

Renault Clio. Right-hand drive


The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.

  1. Side air vent.
  2. Passenger Airbag location.
  3. Heating or air conditioning controls.
  4. Multimedia touch-screen.
  5. Windscreen demister outlet.
  6. Hazard warning lights switch.
  7. Door electric locking switch.
  8. Centre air vents.
  9. Stalk:
  1. Instrument panel.
  2. Driver Airbag and horn location.
  3. Multimedia system voice control button.
  4. Stalk:
  1. Side air vent.
  2. Controls for:
  1. Cruise control/speed limiter controls.
  2. Control for adjusting steering wheel height and reach.
  3. Cruise control/speed limiter main control.
  4. Activation/deactivation control for ECO mode.
  5. Handbrake.
  6. Gear lever.
  7. Cigarette lighter/accessories socket.
  8. RENAULT card reader.
  9. Engine start/stop button.
  10. Storage space.
  11. Glovebox.
  12. Bonnet release control.

READ NEXT:

 Warning lights

The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY. Instrument panel A: lights up when the ignition is switched on. The brightness can be adjusted by turning

 Displays and indicators

Rev counter 1 (graduations x 1000) Speedometer 2 (km or miles per hour) Overspeed buzzer Depending on the vehicle, a buzzer sounds for approximately 10 seconds every 40 seconds, as long

 On-board computer: general information

On-board computer 1 Depending on the vehicle, this includes the following functions: distance travelled; journey settings; information messages; operating fault messages (connected t

SEE MORE:

 Dashboard cross member: Removal - Refitting

Note: In the event of a front impact with triggering of airbags, check the area of connection between both diameters of the beam. If there is any damage visible to the naked eye, this part must be replaced. REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the front doors (see 47A, Side opening

 Particle filter temperature sensors: Removal - Refitting

K9K, and 772 The particle filter must be removed in order to remove the catalytic converter upstream temperature sensor. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment). Disconnect the battery (s

© 2016-2025 Copyright Renault Clio Owners Club