Renault Clio: Drive plate: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Transmission / Automatic Gearbox / Drive plate: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the gearbox (see 23A, Automatic gearbox, Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Set up the (Mot. 582-01) (2).
- Remove:
- the bolts (2),
- the drive plate,
- tool (Mot. 582-01).
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Check that the drive plate is not damaged (run-out tolerance of 0.2 mm on the outer diameter).
II - REFITTING OPERATION FOR PART CONCERNED
- Fit the drive plate, ensuring it is correctly positioned in relation to the centring pins.
- Apply LOCTITE FRENBLOC to the bolt threads.
- Tighten the bolts on the drive plate.
- Torque and angle tighten the drive plate bolts (55
Nm + 50
READ NEXT:
Multifunction switch: Removal - Refitting
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Shift the selector lever to Neutral.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove
the battery tray (se
Speed sensor: Removal - Refitting
DP0
Do not drain or remove the automatic gearbox in order
to remove the speed sensor.
The output speed sensor has been deleted and replaced
with wheel speed sensors.
REMOVAL
I - REMOVAL PREPARATION
Pressure sensor: Removal - Refitting
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on the two-post lift (see 02A,
Lifting equipment, Vehicle: Towing and lifting).
Disconnect the battery (see 80A, Battery, Batter
SEE MORE:
Flow control solenoid valve: Removal - Refitting
DP0
Do not drain or remove the automatic gearbox in order
to remove the flow control solenoid valve
REMOVAL
I - REMOVAL PREPARATION OPERATION
Place the vehicle on a two-post lift (see 02A, Lifting
equipment, Vehicle: Towing and lifting).
Disconnect the battery (see 80A, Battery, Battery:
Remov
Rear screen wash/wipe
Speed-dependent
timed rear screen
wiper
With the ignition on, turn the end of
stalk 1 to align mark 2 with the symbol.
Wiping frequency varies with speed.
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in the park position.
Risk of i
© 2016-2025 Copyright Renault Clio Owners Club
