Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Top And Front Of Engine

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

SEE MORE:

 Driveshaft: Precautions for the repair

DP0 or JH3 or JR5 or TL4 WARNING A gearbox oil leak at the driveshaft may destroy it. WARNING Always replace seals whenever the driveshaft is removed. WARNING Grease the base of the bearing using BR 2 + grease to prevent the bearing from sticking. Make sure that the O-ring is correctly positioned i

 Diesel filter: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the front right-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres), the right-hand wheel arch liner (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection). II - OPERATION FOR

© 2016-2025 Copyright Renault Clio Owners Club