Renault Clio: Manual gear control: Adjustment
Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls / Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A REMOVAL OPERATION
1 - Passenger compartment
- Shift the selector lever to third gear.
- Fit a shim (1) (6 mm between the locking ring and reverse gear interlock on the selector lever.
- Use a strap (2) to immobilise the lever against the shim in third gear position.
2 - Engine compartment
- Position the gear lever on the gearbox in "third gear engaged" position.
- Unlock the selector cable adjustment clip by compressing
the lock ring (3) and push the orange clip
(4) upwards
(1). - Adjust the length of the cable accordingly and fit it onto the gear selection lever ball joint.
- Lock the cable by pressing on the orange clip (5).
- Check that gear selection is correct.
READ NEXT:
Master cylinder: Removal - Refitting
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
Master cylinder - front right-hand calliper brake pipe: Removal - Refitting
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
Master cylinder - front left-hand calliper brake pipe: Removal - Refitting
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
Reversing camera
Operation
Moving into reverse gear, the 1 camera
(located on the tailgate on five-seater
versions or near the number plate lights
on estate versions) provides a view of
the area behind the vehicle on the 2
touchscreen. Depending on the vehicle,
this may be accompanied by a
moving guide l
Front bumper: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR392, 02, Lifting equipment).
Remove:
the lower bolts (1).
the front parts of the front wheel arch liners (see
55A, Exterior protection, Front wheel arch liner:
Remova
© 2016-2025 Copyright Renault Clio Owners Club
