Renault Clio: Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
- Shift the selector lever to third gear.

- Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
- Use a strap (2) to immobilise the lever against the
shim in third gear position.
2 - Engine compartment
- Position the gear lever on the gearbox in "third gear
engaged" position.

- Unlock the selector cable adjustment clip by compressing
the lock ring (3) and push the orange clip
(4) upwards
(1).
- Adjust the length of the cable accordingly and fit it
onto the gear selection lever ball joint.

- Lock the cable by pressing on the orange clip (5).
- Check that gear selection is correct.
READ NEXT:
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
Wiping and washing: List and location of components
Passenger compartment
fuse and relay box
Protection and Switching
Unit
Power supply fuse board
UCH
Rain sensor
Wiper switch
Windscreen wiper motor
Rear screen wiper motor
Washer pump
Headlight washer pump
I - PASSENGER COMPARTMENT FUS
Radio: List and location of components
I - LIST OF COMPONENTS
The radio system comprises:
a radio control satellite (see 86A, Radio, Radio control
satellite: Removal - Refitting, 86A-19)
a radio aerial (see 86A, Radio, Radio aerial: Removal
- Refitting, 86A-11)
a radio (see 86A, Radio, Radio:
© 2016-2026 Copyright Renault Clio Owners Club - 0.0042
