Renault Clio: Rear wheel arch trim: Removal - Refitting

Renault Clio. Rear wheel arch trim: Removal - Refitting

B85 or C85

IMPORTANT

Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see Airbag and pretensioners: Precautions for the repair) (88C, Airbags and pretensioners).

IMPORTANT

To avoid any risk of triggering when working on or near a pyrotechnic component (airbags or pretensioners), lock the airbag computer using the diagnostic tool.

When this function is activated, all the trigger lines are inhibited and the airbag warning light on the instrument panel lights up continuously (ignition on).

IMPORTANT

Never handle the pyrotechnic systems (pretensioners or airbags) near to a source of heat or naked flame - they may be triggered.

REMOVAL

I - REMOVAL PREPARATION OPERATION

B85 or C85

 

B85 or K85

C85

B85 or C85

K85

II - OPERATION FOR REMOVAL OF PART CONCERNED

K85

Renault Clio. Rear wheel arch trim: Removal - Refitting

 

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

K85

B85 or C85

C85

B85 or K85

 

B85 or C85

READ NEXT:

 Windscreen pillar trim: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove the seal (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Unclip the top of the pillar trim at (2). remove the pillar trim by pul

 B-pillar upper trim: Removal - Refitting

C85 REMOVAL REMOVAL PREPARATION OPERATION Remove: the complete rear bench seat, the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32).

 B-pillar trim: Removal - Refitting

B85 REMOVAL I - REMOVAL PREPARATION OPERATION Move the seats fully forward. Partially remove the frame seals (1). Partially unclip the front and rear door sill trims. II - REMOVAL OF PART CONCE

SEE MORE:

 Front driveshaft lower arm ball joint: Check

CHECK CHECKING THE FRONT DRIVESHAFT LOWER ARM BALL JOINT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). 1 - Checking the condition of the front driveshaft lower arm ball joint gaiter Check: the gaiter crimping on the front drivesha

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid valve connector (2), Fit the hose end piece (Mot. 1592) in place of one of the removed plugs.

© 2016-2025 Copyright Renault Clio Owners Club