Renault Clio: Tyre pressure: Identification
Renault Clio III (2005-2013) Service Manual / Chassis / Wheels And Tyres / Tyre pressure: Identification
I - INFLATION
WARNING
If checking the tyre pressure when hot, increase the recommended pressure by 0.2 to 0.3 bar.
B85 or C85 or S85
The pressure values given are recommendations when cold.
K85
II - CONFORMITY CHECK AND ADJUSTMENT
If the tyre size is changed, calibrate the electric power-assisted steering computer using the Diagnostic tool (see MR 394 Fault finding, 36B, Electric power-assisted steering, Replacement of components).
Wheel rim offset:
- steel wheel rim: 43 mm,
- alloy wheel rims: 50 mm.
For information on fitting chains, see " Driver's handbook ".
Tyres: Identification
Example of a tyre identification mark: 205/65 R 15 91 V.
Speed code table:
READ NEXT:
Wheel rim: Identification
IDENTIFICATION
1 - Marking
There are two types of identification marking on the
wheel rims:
engraved marking for steel wheel rims,
cast marking for alloy wheel rims.
The marking gives the main dim
Tyre Pressure Monitor
Tyre pressure monitor: List and location of components
TYRE PRESSURE SENSOR
The system consists of:
four pressure sensors (1) built into the valves (one per
wheel); the sensors transmit a radio si
SEE MORE:
Fuel flow: Check
D4F or K4J or K4M or M4R
IMPORTANT
During this operation, be sure to:
be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear goggles with side protectors for this operation.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this operation.
WARNING
To avoid any corrosion or da
Diesel injection: Precautions for the repair
K9K
I - RISKS RELATING TO CONTAMINATION
The high-pressure direct injection system is highly sensitive
to contamination. The risks caused by contamination
are:
damage to or destruction of the high pressure injection
system,
a component seizing,
a component not being properly sealed.
All After-S
© 2016-2026 Copyright Renault Clio Owners Club - 0.0056
