Renault Clio: Evaporator: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Air Conditioning / Air Conditioning / Evaporator: Removal - Refitting
AIR CONDITIONING or CLIMATE CONTROL
Note: The evaporator is supplied already assembled in the distribution unit. (1)
REMOVAL
OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the distribution unit (see 61A, Heating, Distribution unit: Removal - Refitting, 61A- 50).
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- Refit the distribution unit (see 61A, Heating, Distribution unit: Removal - Refitting, 61A-50).
Evaporator: Cleaning
AIR CONDITIONING or CLIMATE CONTROL
WARNING
Do not spray the cleaner via the air inlet, as this could damage the fan assembly.
REMOVAL
LEFT-HAND DRIVE
- Remove the cabin filter (see 61A, Heating, Cabin filter: Removal - Refitting, 61A-17).
- Apply the air conditioning cleaner using an extension piece.
- Spray the entire aerosol.
- Leave the product to work for 15 minutes.
- Run the fan assembly very slowly for 5 minutes.
RIGHT-HAND DRIVE
- Remove the cabin filter (see 61A, Heating, Cabin filter: Removal - Refitting, 61A-17).
- Apply the air conditioning cleaner.
- Spray the entire aerosol.
- Leave the product to work for 15 minutes.
- Run the fan assembly slowly for 5 minutes.
REFITTING
- Refit the cabin filter.
- Clip on the cabin filter.
READ NEXT:
Expansion valve - intermediate pipe connecting pipe at the expansion valve outlet: Removal -
Refitting
F4R or K9K or M4R, and AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before car
Dehydrator reservoir - expansion valve connecting pipe: Removal - Refitting
AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
Expansion valve - compressor connecting pipe: Removal - Refitting
D4F or K4J or K4M, and AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before car
SEE MORE:
Clutch circuit: Bleed
JH3 or JR5 or TL4
Bleed in the event of:
dead travel,
pedal at mid-travel,
pedal to the floor,
poor gear changing.
I - PRECAUTIONS DURING REPAIR
Risks relating to contamination.
The hydraulic clutch system is very sensitive to contamination.
The risks caused by contamination are:
impossibl
Structural bodywork documentation: Use
B85 or C85
I - CLASSIFYING INFORMATION
This information is classified in two complementary
documents:
1 - Vehicle structure bodywork repair procedures
(MR of the vehicle concerned)
This document comprises two sections:
a - Section 0:
This section does not contain repair methods, it only
contains des
© 2016-2025 Copyright Renault Clio Owners Club
