Renault Clio: Pressure sensor: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Air Conditioning / Air Conditioning / Pressure sensor: Removal - Refitting
AIR CONDITIONING or CLIMATE CONTROL
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
- Remove:
- the front wheels (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection),
- the front bumper (see Front bumper: Removal - Refitting) (MR 393, 55A, Exterior protection).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the pressure sensor connector (1).
Note: An automatic shut-off valve isolates the circuit from the outside during removal; do not drain the refrigerant from the circuit.
- Remove the pressure sensor.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the pressure sensor.
- Tighten the pressure sensor.
- Connect the pressure sensor connector (2).
II - FINAL OPERATION.
- Refit:
- the front bumper (see Front bumper: Removal - Refitting) (MR 393, 55A, Exterior protection),
- the front wheel arch liners (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection),
- the front wheels (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres),
READ NEXT:
Compressor - condenser connecting pipe: Removal - Refitting
AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
Compressor - intermediate pipe connecting pipe: Removal - Refitting
F4R or K9K or M4R, and AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before car
Electrical Equipment
The Renault Clio 4 is equipped with a range of electrical equipment designed to enhance convenience and functionality. This includes features such as power windows, power mirrors, and central locking,
SEE MORE:
Pressure at end of
compression: Check
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid valve connector (2),
Fit the hose end piece (Mot. 1592) in place of one of
the removed plugs.
Exhaust: Precautions for the repair
I - PARTS AND CONSUMABLES FOR THE REPAIR
1 - Parts always to be replaced:
the exhaust trunking (if fitted)
the seal or sealing ring on the connection between the
catalytic converter or catalytic pre-converter and the
rest of the exhaust system
the exhaust clip(s) (if fitted)
2 - Consumables
© 2016-2025 Copyright Renault Clio Owners Club
