Renault Clio: Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
- Shift the selector lever to third gear.

- Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
- Use a strap (2) to immobilise the lever against the
shim in third gear position.
2 - Engine compartment
- Position the gear lever on the gearbox in "third gear
engaged" position.

- Unlock the selector cable adjustment clip by compressing
the lock ring (3) and push the orange clip
(4) upwards
(1).
- Adjust the length of the cable accordingly and fit it
onto the gear selection lever ball joint.

- Lock the cable by pressing on the orange clip (5).
- Check that gear selection is correct.
READ NEXT:
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
On vehicles fitted with this function,
control A allows you to adjust the height
of the beams according to the load.
Turn control A downwards to lower the
headlights and upwards to raise them.
If driving on the left in a left-hand
drive vehicle (or vice versa), drivers
must h
With the ignition on, move stalk 1
A park.
B intermittent wiping.
The wipers will pause for several
seconds between sweeps. It is
possible to change the time between
sweeps by turning ring 2.
C normal wiping speed.
D fast wiping speed.
Positions B, C and D are acces
© 2016-2026 Copyright Renault Clio Owners Club - 0.0048
