Renault Clio: Rear suspension spring: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rear suspension spring: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Remove the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unpick the wheel speed sensor wiring harnesses (1)
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Mark the position where the springs are fitted.
- Remove the shock absorber lower mounting (2).
- Remove the component jack.
- Repeat these operations on the opposite side.
- Remove the springs by withdrawing the component jack.
- Leave the rear axle suspended.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Refit the springs in their housing.
- Compress the rear axle.
- Refit the lower shock absorber mounting bolts.
- Torque tighten the shock absorber lower mounting bolts (105 Nm).
- Mount the wheel speed sensor wiring.
II - FINAL OPERATION.
- Remove the component jack.
- Refit the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
READ NEXT:
Rear drum bearing: Removal - Refitting
Using a dial gauge connected to the drum, check that
the end float is greater than 0.03 mm.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
Rear disc bearing: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 3
Rear stub axle carrier: Removal - Refitting
DISC BRAKE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the rear wheel in questi
SEE MORE:
Transporting objects in the boot
Always position the objects transported
so that the largest surface is against:
The rear bench seatback for normal
loads (example A).
The front seatbacks with the rear
seatbacks folded down, as is the case
for maximum loads (example B).
If you have to place objects on the
Engine oil: Draining - Refilling
D4F or K4J or K4M or K9K
I - RECOMMENDATIONS FOR REPAIR
Direction of fitting of the drain plug seal.
K4J or K4M or K9K
For an aluminium engine oil sump
There is no direction of fitting for a seal fitted with a
rubber lip.
D4F
For a sheet metal engine oil sump
Position the slot (1) of th
© 2016-2025 Copyright Renault Clio Owners Club
