Renault Clio: Air conditioning: Precautions for the repair
Renault Clio III (2005-2013) Service Manual / Air Conditioning / Air Conditioning / Air conditioning: Precautions for the repair
AIR CONDITIONING or CLIMATE CONTROL
I - SAFETY
IMPORTANT
The following must be worn when handling refrigerant:
- gloves,
- protective goggles (with side shields if possible).
In the event of refrigerant fluid coming into contact with the eyes, rinse well with clean water continuously for 15 minutes. If possible, have an eye rinse unit available.
If refrigerant comes into contact with your eyes, consult a doctor immediately. Inform the doctor that the burns were caused by R134A refrigerant.
In the event of contact with other unprotected parts of the body (event though the safety advice has been observed), rinse well with clean water continuously for 15 minutes.
IMPORTANT
Work requiring the use of refrigerant must be carried out in a well-ventilated area.
The refrigerant must not be stored in a shaft, a pit, a hermetically sealed room, etc.
Refrigerants are colourless and odourless fluids.
Refrigerant is heavier than air. As a result there is a risk of asphyxia for those working close to the ground and less than 5 m away from the working area (pit, well, air vents, etc.).
Switch on gas extraction systems.
At temperatures above 100
READ NEXT:
Air conditioning: Check
AIR CONDITIONING or CLIMATE CONTROL
Equipment required
Dual-sensor temperature measuring device
Note:
When performing RENAULT maintenance, check
the air conditioning system at the end of the vehicle's
Refrigerant circuit: Check
AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 62A, Air conditioning, Air conditioning:
Prec
Refrigerant circuit: Draining - Filling
AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 62A, Air conditioning, Air conditioning:
Prec
SEE MORE:
Rear light bulb: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the rear light on the wing (see 81A, Rear
lighting, Rear wing light: Removal - Refitting, 81A-5).
B85 or C85 or S85, and DOCUMENTATION
PHASE 1
Unclip the bulb holder plate (1) by pressing clips (2) and (3).
K85, and DOCUMENTATION PHASE 1
Un
Vehicle on repair bench: Description
I - MAIN REFERENCE POINTS BEFORE TRIM-SETTING
1 - Front sub-frame in place
The jig crowns the front sub-frame rear mounting bolt (A).
Use this situation for a rear impact or a light frontal impact
without removal of the mechanical components.
2 - Front mechanical components removed
The jig rests
