Renault Clio: Cruise Control
Cruise control - speed limiter: List and location of components
CRUISE CONTROL
I - LIST OF COMPONENTS
- Switch
- Steering wheel switch
- Brake switch
- Clutch switch
II - LOCATION OF COMPONENTS
1 - Switch

2 - Steering wheel switch

3 - Brake switch

4 - Clutch switch

Switch: Removal - Refitting
CRUISE CONTROL

REMOVAL
I - REMOVAL PREPARATION OPERATION

- Unclip the switch panel (1) using the (Car. 1363).
- Disconnect the connectors.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the switch by pressing on the clips (2).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit the switch on the switch panel.
- Connect the connectors.
II - FINAL OPERATION.
- Clip the switch panel onto the lower cover.
READ NEXT:
Rotary switch: Removal - Refitting
The rotary switch is part of the steering column control
assembly. It cannot be replaced on its own.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the steering
Wiping and washing: List and location of components
Passenger compartment
fuse and relay box
Protection and Switching
Unit
Power supply fuse board
UCH
Rain sensor
Wiper switch
Windscreen wip
Radio: List and location of components
I - LIST OF COMPONENTS
The radio system comprises:
a radio control satellite (see 86A, Radio, Radio control
satellite: Removal - Refitting, 86A-19)
a radio a
SEE MORE:
Operating principle
Ultrasonic detectors, installed in the
rear bumper (depending on the vehicle),
measure the distance between the
vehicle and an obstacle whilst reversing.
This measurement is indicated by
beeps which become more frequent the
closer you come to the obstacle, until
they be
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
Shift the selector lever to third gear.
Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
Use a strap (2) to immobilise the lever against the
shim
© 2016-2025 Copyright Renault Clio Owners Club
