Renault Clio: Rear bench seat: functions
Position for use
Raise the headrest as far as possible to use it in the high position. Check that it is correctly locked.
Storage position
Press button A and lower the headrest completely.
When the headrest is set at the lowest position, this is for storage only. It should not be in this position when a seat is occupied.
To raise the headrest
Raise the headrest as far as it will go, then press button A and remove the headrest.
To refit the headrest
Enter the rods in their housing and push down the headrest until it locks to use it in the high position. Check that it is correctly locked.
| The headrest is a safety
component; check that it is
fitted and in the correct position. The top of the headrest should be as close as possible to the top of the head. |
To fold down the seatback
Ensure that the front seats are far enough forward.
Lower the headrests fully.
Place the seat belts in their guides A.
Press button 1 and lower the seatback B.
| Before moving the seatback, put the seat belt in belt guide A to avoid damaging it |
To replace the seatback, proceed in the reverse order to removal.
Refit the seatback and click it back into place.
| For safety reasons, carry
out any adjustments when
the vehicle is not being
driven. The configuration of the two-seat bench with the small seatback B pulled down, does not allow the central seat to be used as it would be impossible to buckle the seat belt (belt buckles inaccessible). |
| When moving the rear seats, ensure that nothing obstructs the anchorage points (passenger’s arm or leg, a pet, gravel, cloth, toys, etc.). |
| When refitting the seatback,
make sure it is correctly
locked in place. If seat covers are fitted, make sure these do not prevent the seatback latch from locking in. Make sure that the seat belts are positioned correctly. Reposition the headrests. |
READ NEXT:
Boot
To open
Press button 1 and lift the tailgate.
To close
Lower the tailgate using the handles 2
inside the tailgate to help you
Opening the doors manually from the inside
If it is impossib
Rear parcel shelf
Removal
Lower the rear headrests;
unhook the two cords 1 from the boot
door;
lift the parcel shelf 2 to half height in
order to unclip it (movement A);
push the shelf in (B m
Luggage compartment cover: estate version
To remove the flexible section of the luggage compartment cover 1
Pull handle 2 gently to release the pins
from their mounting points located on
each side of the luggage boot.
Guide the lugg
SEE MORE:
Exhaust: Precautions for the repair
I - PARTS AND CONSUMABLES FOR THE REPAIR
1 - Parts always to be replaced:
the exhaust trunking (if fitted)
the seal or sealing ring on the connection between the
catalytic converter or catalytic pre-converter and the
rest of the exhaust system
the exhaust clip(s) (if fitted)
2 - Consumables
Diesel injection: List and location of components
K9K, and 750 or 760 or 762 or 764 or 766 or 768
High pressure pump
Flow regulation solenoid valve
Pressure regulation solenoid
valve
Diesel temperature sensor
Spacer between the cylinder
head and the injector clamp
Injector clamp
Diesel injector fuel return pipe
Diesel injector
High pre
