Renault Clio: To refit a wheel

A wheel size larger than 15” cannot
be installed under the vehicle. |

To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its own, unwind it again as follows:
- pull the handle to unwind the cable;
- press the button located under
handle 4 to hold the unwound cable,
then guide it down;
- recover the cable from underneath
the vehicle.
You may refit the wheel.

After changing a wheel, position the
replaced wheel on support 7, with the
valve facing the ground. Clip cable 5
in its housing 6, then push the wheel
under the boot.
Ensure that tab 8 is positioned towards
the rear of the vehicle.
Position yourself behind the vehicle and
pull handle 4 to raise the wheel until it is
anchored under the vehicle.
Make sure that no-one has their fingers close to the cable when you
move the handle: risk of injury. |
READ NEXT:
Press nut 3, screwing it on fully until
it locks in place. Several turns will
be necessary. This operation is essential
to ensure that the wheel is
secure;
return handle 4 to its orig
The kit repairs tyres when
tread A has been damaged
by objects smaller
than 4 mm. It cannot repair
all types of puncture, such as cuts
larger than 4 mm, or cuts in tyre
si
The tools included in the tool kit depend
on the vehicle.
Tool kit A is located in the tray under
the luggage compartment carpet.
Lift the cover and remove it.
Wheelbrace 1
Locks or
SEE MORE:
DP0
The automatic transmission series number can be
found in two places: on a label on the hydraulic distributor
cover (1) and etched onto the outer casing (2) on
the wheel side.
Automatic gearbox oil: Draining - Filling
DP0
I - OIL SERVICE
Position the vehicle on a two-post lift (see Vehicle:
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND
COUNTRY
Examples of selections
Interpreting the display selected
a) Total mileage and trip mileage recorder.
b) Journey parameters.
Fuel used.
Fuel consumed since the last
© 2016-2025 Copyright Renault Clio Owners Club
