Renault Clio: Displays and indicators
Rev counter 1 (graduations x 1000)
Speedometer 2 (km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer sounds for approximately 10 seconds every 40 seconds, as long as the vehicle is travelling in excess of 72 mph (120 km/h).
Driving style indicator 4
Please refer to the information on “Driving advice, Eco-driving” in Section 2.
Low engine oil level warning
When the engine is started, display 3 alerts the driver when the oil level is at its minimum. Refer to the information on the “Engine oil level” in Section 4.
Fuel gauge 5
Instrument panel 5 in miles (option to switch to km/h)
- With ignition off, press button 7 or 8 at the end of stalk 6 and the start button 9;
- the speedometer unit indicator flashes for approximately ten seconds, then the new unit is displayed: release button 7 or 8 when the unit stops flashing.
To return to the previous mode, repeat the same operation.
Note: once the battery is switched off, the trip computer and warning system automatically returns to the original unit of measurement.
READ NEXT:
On-board computer: general information
On-board computer 1
Depending on the vehicle, this includes
the following functions:
distance travelled;
journey settings;
information messages;
operating fault messages (connected
t
Trip settings
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND
COUNTRY
Examples of selections
Interpreting the display selected
a) Total mileage and trip
SEE MORE:
Cabin filter: Removal - Refitting
LEFT-HAND DRIVE
Note:
The cabin filter is located in the passenger side A-pillar.
REMOVAL
I - REMOVAL PREPARATION OPERATION
SCHOOL VEHICLE
Remove the clutch pedal (see Clutch pedal: Removal
- Refitting) (MR392, 37A, Mechanical component
controls).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Front left-hand driveshaft gaiter, gearbox side: Removal - Refitting
DP0 or JH3 or JR5 or TL4
Tightening clip
Tightening ring
Cup
Driveshaft yoke sleeve
Deflector
Propeller shaft
RC gaiter
Spider
Lock ring
Spring
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting eq
