Renault Clio: Manual gear control: Adjustment
Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls / Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A REMOVAL OPERATION
1 - Passenger compartment
- Shift the selector lever to third gear.
- Fit a shim (1) (6 mm between the locking ring and reverse gear interlock on the selector lever.
- Use a strap (2) to immobilise the lever against the shim in third gear position.
2 - Engine compartment
- Position the gear lever on the gearbox in "third gear engaged" position.
- Unlock the selector cable adjustment clip by compressing
the lock ring (3) and push the orange clip
(4) upwards
(1). - Adjust the length of the cable accordingly and fit it onto the gear selection lever ball joint.
- Lock the cable by pressing on the orange clip (5).
- Check that gear selection is correct.
READ NEXT:
Master cylinder: Removal - Refitting
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
Master cylinder - front right-hand calliper brake pipe: Removal - Refitting
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
Master cylinder - front left-hand calliper brake pipe: Removal - Refitting
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
Electric windows
These systems operate with the ignition
on or off, until one of the front doors
is opened (limited to about 3 minutes).
Safety of rear occupants
The driver can prevent operation
of the rear electric
windows by pressing
switch 4. A confirmation message is
displayed on the ins
Camshaft dephaser:
Function
I - SPECIAL NOTES
Its role is to modify the valve timing.
To improve cylinder filling at all engine speeds, the engine is fitted with an
inlet camshaft dephaser (1).
Dephasing at the moment when the inlet valves close
optimises filling according to engine speed. Torque at
midrange engine speed an
© 2016-2025 Copyright Renault Clio Owners Club
