Renault Clio: Charge circuit: Specifications
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Starting - Charging / Charge circuit: Specifications
D4F or F4R or K4J or K4M or K9K or M4R
ALTERNATOR SPECIFICATIONS
Charge circuit: Function
D4F or F4R or K4J or K4M or K9K or M4R
OPERATION
These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows:
- when the ignition is switched on, the warning light comes on,
- the warning light goes out when the vehicle is started,
- if the warning light comes on while the engine is running, it indicates a battery charge fault.
Charge circuit: Check
D4F or F4R or K4J or K4M or K9K or M4R
Check the current after 30 minutes of heating at a voltage of 13.5 V.
READ NEXT:
Alternator: Removal - Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove the air inlet
Starter: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the air filter unit (see 12A, Fuel mi
SEE MORE:
Rear panel lining: Removal - Refitting
C85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Remove:
the front seat belt support bolt (1).
the front seat belt support.
Unclip:
the rear section of the front door sill lining (3),
the rear wing panel trim at (4).
II - OPERATION
Parking Distance Control
Parking distance control: List and location of
components
REAR PROXIMITY RADAR
I - LIST OF COMPONENTS
The parking distance control function consists of:
rear proximity sensors,
a parking distance control buzzer,
a parking distance control computer,
a parking distance control switch.
II - LOCA
© 2016-2025 Copyright Renault Clio Owners Club
