Renault Clio: Displays and indicators
Rev counter 1 (graduations x 1000)
Speedometer 2 (km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer sounds for approximately 10 seconds every 40 seconds, as long as the vehicle is travelling in excess of 72 mph (120 km/h).
Driving style indicator 4
Please refer to the information on “Driving advice, Eco-driving” in Section 2.
Low engine oil level warning
When the engine is started, display 3 alerts the driver when the oil level is at its minimum. Refer to the information on the “Engine oil level” in Section 4.
Fuel gauge 5
Instrument panel 5 in miles (option to switch to km/h)
- With ignition off, press button 7 or 8 at the end of stalk 6 and the start button 9;
- the speedometer unit indicator flashes for approximately ten seconds, then the new unit is displayed: release button 7 or 8 when the unit stops flashing.
To return to the previous mode, repeat the same operation.
Note: once the battery is switched off, the trip computer and warning system automatically returns to the original unit of measurement.
READ NEXT:
On-board computer: general information
On-board computer 1
Depending on the vehicle, this includes
the following functions:
distance travelled;
journey settings;
information messages;
operating fault messages (connected
t
Trip settings
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND
COUNTRY
Examples of selections
Interpreting the display selected
a) Total mileage and trip
SEE MORE:
Driveshaft: Precautions for the repair
DP0 or JH3 or JR5 or TL4
WARNING
A gearbox oil leak at the driveshaft may destroy it.
WARNING
Always replace seals whenever the driveshaft is
removed.
WARNING
Grease the base of the bearing using BR 2 +
grease to prevent the bearing from sticking.
Make sure that the O-ring is correctly positioned i
Engine cooling fan assembly: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the engine cover,
the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the air filter inlet
