Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Multifunction switch: Removal - Refitting

DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Shift the selector lever to Neutral. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the battery tray (se

 Speed sensor: Removal - Refitting

DP0 Do not drain or remove the automatic gearbox in order to remove the speed sensor. The output speed sensor has been deleted and replaced with wheel speed sensors. REMOVAL I - REMOVAL PREPARATION

 Pressure sensor: Removal - Refitting

DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on the two-post lift (see 02A, Lifting equipment, Vehicle: Towing and lifting). Disconnect the battery (see 80A, Battery, Batter

SEE MORE:

 Rear Upper Structure

Rear wing panel: General description Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading the following general information, make sure that there are no special notes associated with the vehicle

 Renault anti-intruder device (raid)

Operating principle After the vehicle is started, the system automatically locks the doors when you are driving at approximately 6 mph (10 km/h) and over. The door can be unlocked: by pressing the door unlocking button 1. by opening a front door (vehicle stationary). NB: if a d

© 2016-2026 Copyright Renault Clio Owners Club