Renault Clio: Rubber bush: Adjustment
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rubber bush: Adjustment
WARNING
Never use the rear axle as support for a lifting system.
ADJUSTMENT
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Release the parking brake.
- Remove the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
- Unclip the speed sensor harness at (1).
- Loosen the rubber bush nuts (2).
- Remove the springs (see 33A, Rear axle components, Rear suspension spring: Removal - Refitting, 33A-27).
- Place the tool component jack in contact with a shim under the rear axle near the shock absorber at (3).
- Adjust the component jack in order to obtain a distance (X1) of 150 mm between the lower mounting of the shock absorber and the side member.
- Torque tighten the rubber bush bolt (105 N.m).
- Do the same for the other side.
- Refit the springs (see 33A, Rear axle components, Rear suspension spring: Removal - Refitting, 33A-27).
- Clip on the speed sensor harness.
- Refit the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
READ NEXT:
Rear brake pads: Removal - Refitting
16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and
ELECTRONIC STABILITY
PROGRAM
When replacing brake pads, be sure to replace the
pads on the opposite side.
WARNING
To avoid damag
Rear brake hose: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to p
Rear brake calliper: Repair
WARNING
Prepare for the flow of fluid, and protect the surrounding
components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (
SEE MORE:
Front seat: Stripping - Rebuilding
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 1
IMPORTANT
Before carrying out any work on a safety or proximity
system component, lock the airbag computer
using the Diagnostic tool. When this function is
activated all the ignition lines are disabled and the
airbag warning light on the instrument pan
3rd brake light: Removal - Refitting
B85 or C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the blanking covers (1).
Insert a screwdriver in the openings to move the clips (2).
Apply pressure to the clips (2) to unclip the high level
brake light.
Partially remove the raised brake light using a flat-blade
© 2016-2025 Copyright Renault Clio Owners Club
