Renault Clio: Manual gearbox: Identification
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox / Manual gearbox: Identification
JA3 or JA5 or JH3 or JR5
K4J / K4M / K9K / D4F engines are fitted with type JH and JR manual gearboxes.
A marking (1) on the gearbox casing indicates:
- Gearbox type
- Gearbox suffix
- Production plant
- Production number
K9K, and TL4 - F4R, and 830, and TL4
- Identification plate
- Engraving
- Gearbox type
- Gearbox suffix
- Production plant
- Production number
Manual gearbox oils: Draining - Filling
JH3 or JR5
Capacity (in litres)
DRAINING
- Remove:
- the engine undertray mounting bolts,
- the engine undertray.
JH3
- Remove the drain plug (1).
JR5
- Remove the drain plug (2).
FILLING
- It is essential to replace the drain plug seal.
- Refit the drain plug.
JH3
- Remove the filler cap (3).
JR5
- Remove the filler cap (4).
- Fill up to the level of the opening with oil recommended by the manufacturer (see Manual gearbox oil: Specifications) (Technical Note 6012A, 04, Lubricants).
- Refit the filler cap.
- Refit:
- the engine undertray,
- the engine undertray mounting bolts.
Manual gearbox: Specifications
JA3 or JA5 or JH3 or JR5
GEAR RATIOS
TL4
GEAR RATIOS
READ NEXT:
Manual gearbox: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
IMPORTANT
During this operation, secure the vehicle to the
lift wi
Input shaft lip seal: Removal - Refitting
JH3 or JR5
Replace the lip seal after opening the gearbox (see
Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the gearbox (see 21A, Manual gearb
Differential output seal: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Batter
SEE MORE:
Front seat: Stripping - Rebuilding
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 1
IMPORTANT
Before carrying out any work on a safety or proximity
system component, lock the airbag computer
using the Diagnostic tool. When this function is
activated all the ignition lines are disabled and the
airbag warning light on the instrument pan
K4M
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray bolts,
the engine undertray,
the battery (see Battery: Removal - Refitting)
(80A, Battery),
the battery tray (see
© 2016-2025 Copyright Renault Clio Owners Club
