Renault Clio: Pre-postheating unit: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Preheating / Pre-postheating unit: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the battery (see Battery: Removal - Refitting),
- the battery tray (see Battery tray: Removal - Refitting) (MR 392, 80A, Battery).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the pre-postheating unit mounting bolt (8).
- Disconnect the pre-postheating unit connector (9).
- Remove the pre-postheating unit.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Connect the pre-postheating unit connector.
- Refit the pre-postheating unit.
- Tighten to torque the pre-postheating unit mounting nut (9 Nm).
II - FINAL OPERATION.
- Refit the battery (see Battery: Removal - Refitting)
READ NEXT:
Heater plugs: Removal - Refitting
K9K, and 764 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter box inlet air pipe (1).
Remove the turbocharger outlet air pipe retaining pins (2).
Remove:
the turbochar
Exhaust gas recirculation: List and location of components
K9K
K9K, and 764 or 766 or 768 or 772
First fitting of the exhaust gas cooler recirculation
assembly
(1) Exhaust gas recirculation solenoid
valve
(2) Exhaust gas cooler
(3) Exhaust gas inlet pipe
(4)
SEE MORE:
Dashboard: Removal - Refitting
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
(see Airbag and pretensioners: Precautions
for the repair) (88C, Airbag and pretensioners),
(see Vehicle: Precautions for the repair)
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not open the expansion bottle cap,
do not drain the cooling system,
do not open the bleed screw(s).
N
© 2016-2025 Copyright Renault Clio Owners Club
