Renault Clio: Rear wing light: Removal - Refitting
B85 or C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
- Open the luggage compartment.

- Remove the bolts from the rear wing light (1).
- Remove the rear wing light.
- Disconnect the connector from the rear light on the
wing.
- Remove the rear light.
- If replacing the rear light, remove the bulbs (see
81A, Rear lighting, Rear light bulb: Removal - Refitting, 81A-7).
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- If replacing the rear light, refit the bulbs (see 81A,
Rear lighting, Rear light bulb: Removal - Refitting, 81A-7).
- Connect the connector for the rear light on the wing.

- Position the rear light on the wing using the centring devices (2).
- Refit the bolts for the rear light on the wing.
- Close the luggage compartment.
K85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
- Open the luggage compartment.

- Remove the bolts from the rear wing light (1).
- Remove the rear wing light.
- Disconnect the connector from the rear light on the
wing.
- Remove the rear light.
- If replacing the rear light, remove the bulbs (see
81A, Rear lighting, Rear light bulb: Removal - Refitting, 81A-7).
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- If replacing the rear light, refit the bulbs (see 81A,
Rear lighting, Rear light bulb: Removal - Refitting, 81A-7).
- Connect the connector for the rear light on the wing.

- Position the rear light on the wing using the centring devices (2).
- Refit the bolts for the rear light on the wing.
- Close the luggage compartment.
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the rear light on the wing (see 81A, Rear
lighting, Rear wing light: Removal - Refitting, 81A-5).
B85 or C85 or S85, and DOCUMENTATION
PHASE 1
U
B85 or C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the blanking covers (1).
Insert a screwdriver in the openings to move the clips (2).
Apply pressure to the clips (2)
K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the tailgate spoiler (see Tailgate spoiler: Removal - Refitting),
the high level brake light (see 81A, Rear lighting,
3rd brake light: Rem
SEE MORE:
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
DISC BRAKE
Brake discs cannot be reground. If there is excessive
scoring or wear, they will need to be replaced (see
30A, General information, Brake: Specifications, 30A-9).
When replacing a brake disc, be sure to replace the
disc on the opposite side.
Be sure to replace the brake pads if the bra
© 2016-2025 Copyright Renault Clio Owners Club
