Renault Clio: Oil vapour rebreathing circuit: Descriptions
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Antipollution / Oil vapour rebreathing circuit: Descriptions
K4J or K4M, and 780 or 800 or 801
- Oil vapour rebreathing duct
- Calibrated port
- Oil vapour recovery plate located on the rocker cover
- Oil vapour rebreathing hole
Oil vapour rebreathing circuit: Operating diagram
K4J, and 780 - K4M, and 800 or 801
A: under low loads, the oil vapours are rebreathed in small quantities through the calibrated orifice (6).
B: under medium and heavy loads, the oil vapours are rebreathed in large quantities through the valve
- Engine
- Oil vapour recovery plate
- Motorised throttle valve
- Inlet manifold
- Air inlet
- Calibrated choke
D4F
The oil decanter is located in the rocker cover.
These two components are manufactured together.
- Engine
- Rocker cover
- Inlet manifold
- Air filter unit
- Motorised throttle valve
K9K, and 750 or 752 or 764 or 766 or 768
A: Low load
B: Medium and high loads
- Rocker cover
- Oil vapour rebreathing duct
- Oil vapour rebreathing valve
- Air inlet duct
- Turbocharger
- Atmospheric pressure
A: At low load, the vacuum pressure prevailing in the air inlet duct is below the spring calibration. Large quantities of oil vapour are sucked back in by the vacuum prevailing in the air inlet duct.
B: At medium or high load, the vacuum pressure prevailing in the air inlet duct pulls the valve diaphragm, small quantities of oil vapour are rebreathed in via a calibrated jet.
F4R, and 830
Operating diagram of the oil vapour rebreathing circuit for average and high loads
Operating diagram of the oil vapour rebreathing circuit for low loads
- Engine
- Oil separator
- Air filter unit
- Throttle valve
- Inlet manifold
- Air inlet
READ NEXT:
Charge circuit: Specifications
D4F or F4R or K4J or K4M or K9K or M4R
ALTERNATOR SPECIFICATIONS
Charge circuit: Function
D4F or F4R or K4J or K4M or K9K or M4R
OPERATION
These vehicles are fitted with a built-in regulator and an
i
Alternator: Removal - Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove the air inlet
SEE MORE:
Boot storage
Mobile floor
When fitted to the vehicle, it can be
used to make loading easier.
Note: if you need to access the ISOFIX
ring and/or the net ring at the bottom of
the boot, open flap 3.
Maximum weight for the mobile
floor: 100 kg evenly distributed.
Movable floor storage
Wheel: Removal - Refitting
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
The removal - refitting procedure is the same for alloy
and steel wheels.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the ve
