Renault Clio: Passenger compartment temperature sensor: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION


- Unclip the lower casing (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Disconnect the passenger compartment temperature sensor connector (2).
- Remove:
- the passenger compartment temperature sensor
bolts located inside the lower cover,
- the passenger compartment temperature sensor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED

- Refit:
- the passenger compartment temperature sensor,
- the passenger compartment temperature sensor
bolts located inside the lower cover.
- Connect the passenger compartment temperature sensor connector (3).
II - FINAL OPERATION.
- Clip on:
- the lower cowling
- the upper cover.
Exterior air temperature sensor: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the door mirror glass (see Door mirror glass: Removal - Refitting),
- the door mirror casing (see Door mirror casing: Removal -
Refitting).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the exterior temperature sensor using a flat-blade
screwdriver.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Replace the exterior temperature sensor (see Technical
Note 6015A, Electrical wiring repair, 88A,
Wiring).
- Clip on the exterior temperature sensor.
II - FINAL OPERATION.
- Refit:
- the door mirror glass (see Door mirror glass: Removal - Refitting),
- the door mirror casing (see Door mirror casing: Removal -
Refitting).
Solar radiation sensor: Removal - Refitting
CLIMATE CONTROL

REMOVAL
I - REMOVAL PREPARATION OPERATION

- Unclip the display mounting using tool (Car. 1597).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the solar radiation sensor (1) from underneath
the dashboard.
- Disconnect the solar radiation sensor.
- Remove the solar radiation sensor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED

- Connect the solar radiation sensor.
- Refit the solar radiation sensor (2).
II - FINAL OPERATION.
- Clip on the display mounting.
READ NEXT:
AIR CONDITIONING or CLIMATE CONTROL
I - SAFETY
IMPORTANT
The following must be worn when handling refrigerant:
gloves,
protective goggles (with side shields if possible).
In the event of refrigera
AIR CONDITIONING or CLIMATE CONTROL
Equipment required
Dual-sensor temperature measuring device
Note:
When performing RENAULT maintenance, check
the air conditioning system at the end of the vehicle's
SEE MORE:
JH3 or JR5
Note:
Each time an operation is carried out on the
hydraulic clutch system, bleed the circuit:
between the reservoir and the bleed hole,
between the bleed hole and the clutch release
bearing.
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M
Remove the resonator.
Remov
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
to unlock the steering column lock (see Fault finding
- Replacement of components) (MR 394, 88C,
Airbags and seat belt pretensioners).
Unclip trim (1).
Unclip:
the plasti-rivet (2),
the bol
© 2016-2025 Copyright Renault Clio Owners Club
