Renault Clio: Steering wheel/Power-assisted steering
Renault Clio IV (2014-2019) Owners Manual / Getting to know your vehicle / Steering wheel/Power-assisted steering
Adjusting the steering wheel height and depth
Pull lever 1 and place the steering wheel in the required position; push the lever beyond the point of resistance to lock the steering wheel in place.
Make sure that the steering wheel is correctly locked.
| For safety reasons, only adjust the steering wheel when the vehicle is stationary. |
Power Assisted Steering
Never drive with an inadequately charged battery.
Variable power assisted steering
The variable power assisted steering system is equipped with an electronic control system which alters the level of assistance to suit the vehicle speed.
Steering is made easier during parking manoeuvres (for added comfort) whilst the force needed to steer increases progressively as the speed rises (for enhanced safety at high speeds).
| Never leave the steering wheel at full lock while stationary. |
| With the engine switched off, or if there is a system fault, it is still possible to turn the steering wheel. The force required will be greater. |
| Never switch off the ignition when travelling downhill, and avoid doing so in normal driving (assistance is not provided). |
READ NEXT:
Left-hand drive
The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
Side air vent.
Stalk for:
direction indicator lights;
exterior lights;
front fog lights;
rear fog light
Right-hand drive
The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
Side air vent.
Passenger Airbag location.
Heating or air conditioning controls.
Multimedia touch-screen.
Wind
SEE MORE:
Front brake calliper: Removal - Refitting
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
Note:
The callipers supplied as replacement parts are
pre-filled.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on
Particle filter temperature sensors: Removal -
Refitting
K9K, and 772
The particle filter must be removed in order to remove
the catalytic converter upstream temperature sensor.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (s
© 2016-2025 Copyright Renault Clio Owners Club
