Renault Clio: Manual gearbox: Identification

JA3 or JA5 or JH3 or JR5

K4J / K4M / K9K / D4F engines are fitted with type JH and JR manual gearboxes.

A marking (1) on the gearbox casing indicates:

Renault Clio. Manual Gearbox

  1. Gearbox type
  2. Gearbox suffix
  3. Production plant
  4. Production number

K9K, and TL4 - F4R, and 830, and TL4

Renault Clio. Manual gearbox

  1. Identification plate
  2. Engraving

Renault Clio. Manual gearbox

  1. Gearbox type
  2. Gearbox suffix
  3. Production plant
  4. Production number

Manual gearbox oils: Draining - Filling

JH3 or JR5

Capacity (in litres)

DRAINING

JH3

Renault Clio. Manual gearbox

JR5

Renault Clio. Manual gearbox

FILLING

JH3

Renault Clio. Manual gearbox

JR5

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Manual gearbox: Specifications

JA3 or JA5 or JH3 or JR5

GEAR RATIOS

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

TL4

GEAR RATIOS

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

READ NEXT:

 Manual gearbox: Removal - Refitting

JH3 or JR5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). IMPORTANT During this operation, secure the vehicle to the lift wi

 Input shaft lip seal: Removal - Refitting

JH3 or JR5 Replace the lip seal after opening the gearbox (see Technical Note 3661A, gearbox JH - JR). TL4 REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the gearbox (see 21A, Manual gearb

 Differential output seal: Removal - Refitting

JH3 or JR5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Batter

SEE MORE:

 Recirculation control cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base of the dashboard. Unclip the trim piece (4) from the driver's side dashboard lower cover. Remo

 Headlight: Adjustment

DOCUMENTATION PHASE 1 ADJUSTMENT I - PREPARATION OPERATION FOR CHECK Place the vehicle in a working area equipped with a two-post lift. Note: Check that the lift is on flat, horizontal ground. Do not apply the parking brake. Check and inflate the tyres to the recommended pressure (see Tyre

© 2016-2025 Copyright Renault Clio Owners Club