Renault Clio: To lock the system

Renault Clio. To lock the system


NB: if the tool kit does not lock in place, check the tightness of nut 3 and the correct positioning of handle 4.

Special features

The emergency spare wheel holder should always be present when you are driving even when the wheel itself is not present: risk of water entering the vehicle.

If you have to release it when it is not holding a wheel, push the centre of the wheel holder towards the ground while pressing handle 4.

It is essential to lock the nut so that the wheel is held securely.

The system should only be used with the original vehicle wheels or identical wheels.

READ NEXT:

 Tyre inflation kit

The kit repairs tyres when tread A has been damaged by objects smaller than 4 mm. It cannot repair all types of puncture, such as cuts larger than 4 mm, or cuts in tyre si

 Tools

The tools included in the tool kit depend on the vehicle. Tool kit A is located in the tray under the luggage compartment carpet. Lift the cover and remove it. Wheelbrace 1 Locks or

 Wheel trims - wheel

Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2. To refit it, align it with valve 2. Push the retaining hooks in fully,

SEE MORE:

 Sunroof sun visors: Removal - Refitting

PANORAMIC SUNROOF IMPORTANT Before working on or near a safety system component; make sure that the airbag computer is locked using the Diagnostic tool. When this function is activated, all the triggering lines are inhibited and the airbag warning light on the instrument panel is continuously lit (

 Rear wing light: Removal - Refitting

B85 or C85 or S85 REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Open the luggage compartment. Remove the bolts from the rear wing light (1). Remove the rear wing light. Disconnect the connector from the rear light on the wing. Remove the rear light. If replacing the rear light, remove t

© 2016-2025 Copyright Renault Clio Owners Club