Renault Clio manuals

Renault Clio: Wipers (replacing blades)

Renault Clio IV (2014-2019) Owners Manual / Practical advice / Wipers (replacing blades)

Replacing windscreen wiper blades 1

Renault Clio. Wipers


Renault Clio. Wipers


Lower tab 3, by pressing on either side A.

Then push the blade forwards B, to release hook 4.

To refit

To refit the wiper blade, proceed in reverse order to removal. Make sure that the blade is correctly locked in position.

Check the condition of the wiper blades. You are responsible for their service life:
  • clean the blades, windscreen and rear screen regularly with soapy water;
  • do not use them when the windscreen or rear screen are dry;
  • free them from the windscreen or rear screen when they have not been used for a long time.

  • In frosty weather, make sure that the wiper blades are not stuck by ice (to avoid the risk of the motor overheating).
  • Check the condition of the wiper blades.

    Replace the wiper blades as soon as they begin to lose efficiency (approximately once a year).

Whilst changing the blade, take care not to drop the arm onto the window after it has been removed as this may break the window.

Rear screen wiper blade 5

Renault Clio. Rear screen wiper blade


To refit

To refit the wiper blade, proceed in reverse order to removal. Make sure that the blade is correctly locked in position

  • In frosty weather, make sure that the wiper blades are not stuck by ice (to avoid the risk of the motor overheating).
  • Check the condition of the wiper blades.

Replace the wiper blades as soon as they begin to lose efficiency (approximately once a year).

Whilst changing the blade, take care not to drop the arm onto the window after it has been removed as this may break the window.

Check the condition of the wiper blades. You are responsible for their service life:
  • clean the blades, windscreen and rear screen regularly with soapy water;
  • do not use them when the windscreen or rear screen are dry;
  • free them from the windscreen or rear screen when they have not been used for a long time.

READ NEXT:

 Towing

Before towing, unlock the steering column: with the clutch depressed, engage first gear (lever in position N or R for vehicles with automatic gearboxes), insert the RENAULT card in the card reade

 Towing a vehicle with an automatic gearbox

With the engine switched off, the transmission is no longer lubricated. It is preferable to tow this type of vehicle on a trailer or tow it with the front wheels off the ground. Under exception

 Access to towing points

Unclip cover 4 or 6 by sliding a flat tool (or the key integrated in the RENAULT card) under the cover. Tighten towing hitch 3 fully: as much as possible by hand at first, then finish tight

SEE MORE:

 3rd brake light: Removal - Refitting

B85 or C85 or S85 REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Remove the blanking covers (1). Insert a screwdriver in the openings to move the clips (2). Apply pressure to the clips (2) to unclip the high level brake light. Partially remove the raised brake light using a flat-blade

 To refit a wheel

A wheel size larger than 15” cannot be installed under the vehicle. To carry out this operation, the cable must be unwound. If the cable has been wound back up on its own, unwind it again as follows: pull the handle to unwind the cable; press the button located u

© 2016-2025 Copyright Renault Clio Owners Club