Renault Clio: Crankshaft accessories pulley: Removal - Refitting

D4F, and 740 or 742 or 764

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
• Remove:
  • the front right-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres),
  • the front right-hand wheel arch liner (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection),
  • the accessories belt (see 11A, Top and front of engine, Accessories belt: Removal - Refitting, 11A-5).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Remove:
  • the flywheel cover mounting bolt (1),
  • the flywheel cover.

• Fit the immobilising tool (Mot. 582-01) (2).
• Remove:
  • the accessories pulley mounting bolt,
  • the accessories pulley.

REFITTING

I - REFITTING PREPARATION OPERATION

WARNING

You must replace the crankshaft accessories pulley mounting bolt.

• Clean the crankshaft accessories pulley grooves with a wire brush to ensure there are no deposits.

II - REFITTING OPERATION FOR PART CONCERNED

• Refit the crankshaft accessories pulley using a new bolt.
• Torque tighten the crankshaft accessories pulley mounting bolt (40 N.m + 70

  READ NEXT:

   Timing belt: Removal - Refitting

   D4F

  REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal

   K4M

  REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the engine undertray bolts, the engine u

  SEE MORE:

    K9K, and Right-hand Drive

  REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove: the engine cover, the engine undertray, the scu

    D4F, and Left-hand Drive

  REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Disconnect the battery (see Battery: Removal - Refitting). Remove: the non-return valve (1) from the servo, the master cylinder (see 37A, Mechanical component controls, Maste