Renault Clio: Pre-postheating unit: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Preheating / Pre-postheating unit: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the battery (see Battery: Removal - Refitting),
- the battery tray (see Battery tray: Removal - Refitting) (MR 392, 80A, Battery).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the pre-postheating unit mounting bolt (8).
- Disconnect the pre-postheating unit connector (9).
- Remove the pre-postheating unit.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Connect the pre-postheating unit connector.
- Refit the pre-postheating unit.
- Tighten to torque the pre-postheating unit mounting nut (9 Nm).
II - FINAL OPERATION.
- Refit the battery (see Battery: Removal - Refitting)
READ NEXT:
Heater plugs: Removal - Refitting
K9K, and 764 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter box inlet air pipe (1).
Remove the turbocharger outlet air pipe retaining pins (2).
Remove:
the turbochar
Exhaust gas recirculation: List and location of components
K9K
K9K, and 764 or 766 or 768 or 772
First fitting of the exhaust gas cooler recirculation
assembly
(1) Exhaust gas recirculation solenoid
valve
(2) Exhaust gas cooler
(3) Exhaust gas inlet pipe
(4)
SEE MORE:
Rear axle system: Tightening torque
Rear axle assembly: Adjustment values
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
I - PRELIMINARY OPERATIONS
Before checking the axles on the test bench, check the
tyre press
Rigid brake pipe: Repair
This procedure applies to copper pipes diameter 4.7
mm.
Note:
This procedure does not apply to:
hybrid pipes (pipe + hose),
pipes with diameters 6 mm and 8 mm.
REPAIR
I - PIPE PREPARATION OPERATION
WARNING
To avoid causing a breakdown in hydraulic brake
circuit, do not squash or bend the rigid
© 2016-2026 Copyright Renault Clio Owners Club - 0.0044
