Renault Clio: Tyre pressure: Identification
Renault Clio III (2005-2013) Service Manual / Chassis / Wheels And Tyres / Tyre pressure: Identification
I - INFLATION
WARNING
If checking the tyre pressure when hot, increase the recommended pressure by 0.2 to 0.3 bar.
B85 or C85 or S85
The pressure values given are recommendations when cold.
K85
II - CONFORMITY CHECK AND ADJUSTMENT
If the tyre size is changed, calibrate the electric power-assisted steering computer using the Diagnostic tool (see MR 394 Fault finding, 36B, Electric power-assisted steering, Replacement of components).
Wheel rim offset:
- steel wheel rim: 43 mm,
- alloy wheel rims: 50 mm.
For information on fitting chains, see " Driver's handbook ".
Tyres: Identification
Example of a tyre identification mark: 205/65 R 15 91 V.
Speed code table:
READ NEXT:
Wheel rim: Identification
IDENTIFICATION
1 - Marking
There are two types of identification marking on the
wheel rims:
engraved marking for steel wheel rims,
cast marking for alloy wheel rims.
The marking gives the main dim
Tyre Pressure Monitor
Tyre pressure monitor: List and location of components
TYRE PRESSURE SENSOR
The system consists of:
four pressure sensors (1) built into the valves (one per
wheel); the sensors transmit a radio si
SEE MORE:
Structural components to be positioned on the repair bench: Description
I - PARTS REQUIRING THE USE OF A BODY JIG
BENCH
Radiator cross member support
Centre floor front side cross member
Front side member closure panel
Front side member
Engine stand
Front half-unit
Front wheel arch
Engine tie-rod attachment
Inner rear wheel arch
Rear side member
Rear sectio
Front end lower cross member: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehicle.
These special notes are specified if necessa
© 2016-2026 Copyright Renault Clio Owners Club - 0.004
