Renault Clio: Displays and indicators
Rev counter 1 (graduations x 1000)
Speedometer 2 (km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer sounds for approximately 10 seconds every 40 seconds, as long as the vehicle is travelling in excess of 72 mph (120 km/h).
Driving style indicator 4
Please refer to the information on “Driving advice, Eco-driving” in Section 2.
Low engine oil level warning
When the engine is started, display 3 alerts the driver when the oil level is at its minimum. Refer to the information on the “Engine oil level” in Section 4.
Fuel gauge 5
Instrument panel 5 in miles (option to switch to km/h)
- With ignition off, press button 7 or 8 at the end of stalk 6 and the start button 9;
- the speedometer unit indicator flashes for approximately ten seconds, then the new unit is displayed: release button 7 or 8 when the unit stops flashing.
To return to the previous mode, repeat the same operation.
Note: once the battery is switched off, the trip computer and warning system automatically returns to the original unit of measurement.
READ NEXT:
On-board computer: general information
On-board computer 1
Depending on the vehicle, this includes
the following functions:
distance travelled;
journey settings;
information messages;
operating fault messages (connected
t
Trip settings
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND
COUNTRY
Examples of selections
Interpreting the display selected
a) Total mileage and trip
SEE MORE:
Brake circuit: Operating diagram
" X " braking system with load-sensitive
compensator
IMPORTANT
This is a diagram of the general principle, do not
use it as a reference for take-off points or circuit
allocation. When replacing components in a vehicle's
braking circuit, always mark the pipes before
removing them.
" X " braking syst
Braking circuit: Bleed
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 30A, General information, Brake circuit:
Precautions for the repair, 30A-2).
This procedure must be applied after one of the followin
