Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the gearbox (see Automatic gearbox: Removal - Refitting).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Set up the (Mot. 582-01) (2).
• Remove:
  • the bolts (2),
  • the drive plate,
  • tool (Mot. 582-01).

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Check that the drive plate is not damaged (run-out tolerance of 0.2 mm on the outer diameter).

II - REFITTING OPERATION FOR PART CONCERNED

• Fit the drive plate, ensuring it is correctly positioned in relation to the centring pins.
• Apply LOCTITE FRENBLOC to the bolt threads.
• Tighten the bolts on the drive plate.
• Torque and angle tighten the drive plate bolts (55 Nm + 50

  READ NEXT:

   Top And Front Of Engine

   Pressure at end of compression: Check

  K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

   Accessories belt: Removal - Refitting

  K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

  SEE MORE:

    Front (chest-level) side airbag: Removal - Refitting

  The front chest level side air bag is mounted on the back of each front seat at the door side. When it inflates, the airbag tears open the cover of the module and the foam and unclips the seat cover. IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying

    Side curtain airbag: Removal - Refitting

  FRONT SIDE + CURTAIN AIRBAG The curtain airbag is mounted behind the headlining and the quarter panel trim. The airbag detaches the headlining when it inflates. IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88C, Air bag and Pr