Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the gearbox (see Automatic gearbox: Removal - Refitting).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Set up the (Mot. 582-01) (2).
• Remove:
  • the bolts (2),
  • the drive plate,
  • tool (Mot. 582-01).

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Check that the drive plate is not damaged (run-out tolerance of 0.2 mm on the outer diameter).

II - REFITTING OPERATION FOR PART CONCERNED

• Fit the drive plate, ensuring it is correctly positioned in relation to the centring pins.
• Apply LOCTITE FRENBLOC to the bolt threads.
• Tighten the bolts on the drive plate.
• Torque and angle tighten the drive plate bolts (55 Nm + 50

  READ NEXT:

   Top And Front Of Engine

   Pressure at end of compression: Check

  K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

   Accessories belt: Removal - Refitting

  K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

  SEE MORE:

    Emergency brake assist

  This system supplements the ABS and helps reduce vehicle stopping distances. Operating principle The system is for detecting an emergency braking situation. In this case, the braking assistance immediately develops maximum power and may trigger ABS regulation. ABS braking is maintained as

    Hill start assistance

  This function assists the driver when starting on hills. It prevents the vehicle from rolling backwards, depending on the slope, by automatically applying the brakes when the driver lifts his/her foot off the brake pedal to depress the accelerator pedal. System operation It only operates whe