Renault Clio: Heating: List and location of components
Renault Clio III (2005-2013) Service Manual / Air Conditioning / Heating / Heating: List and location of components
LEFT-HAND DRIVE
- Control panel
- Cabin filter
- Rear air distribution duct
- Recirculation control cable
- Air distribution cable
- Air mixing cable
- Air distribution unit
- Heater matrix
- Fan assembly
- Heating resistor relay
- Heating resistors:
- Blower control unit.
- Front side air distribution duct
- Front central air distribution duct
- A-pillar air distribution duct
- External temperature sensor
CLIMATE CONTROL
- Passenger compartment temperature sensor
- Solar radiation sensor
The evaporator is supplied already assembled in the distribution unit. (7)
CLIMATE CONTROL
CLIMATE CONTROL
CLIMATE CONTROL
- Motor-driven fan assembly control unit
- Mixing motor
- Wiring harnesses
- Recirculation motor
- Distribution motor
- Fan assembly
- Cabin filter
- Heater matrix pipes
- Heater matrix
- Heater resistance
- Air distribution unit
- Heater matrix pipe mounting bracket
RIGHT-HAND DRIVE
- Control panel
- Cabin filter
- Rear air distribution duct
- Recirculation control cable
- Air distribution cable
- Air mixing cable
- Air distribution unit
- Heater matrix
- Fan assembly
- Heating resistor relay
- Heating resistors:
- Blower control unit.
- Front side air distribution duct
- Front central air distribution duct
- A-pillar air distribution duct
- External temperature sensor
CLIMATE CONTROL
- Passenger compartment temperature sensor
- Solar radiation sensor
The evaporator is supplied already assembled in the distribution unit. (7)
CLIMATE CONTROL
CLIMATE CONTROL
CLIMATE CONTROL
- Motor-driven fan assembly control unit
- Mixing motor
- Wiring harnesses
- Recirculation motor
- Distribution motor
- Fan assembly
- Cabin filter
- Heater matrix pipes
- Heater matrix
- Heating resistors:
- Air distribution unit
- Heater matrix pipe mounting bracket
READ NEXT:
Cabin filter: Removal - Refitting
LEFT-HAND DRIVE
Note:
The cabin filter is located in the passenger side A-pillar.
REMOVAL
I - REMOVAL PREPARATION OPERATION
SCHOOL VEHICLE
Remove the clutch pedal (see Clutch pedal: Removal
- Refit
Rear air distribution duct: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 88C, Airbags and pretensioners).
Disconnect
Recirculation control cable: Removal - Refitting
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove seal (1).
Remove the side panel (2).
Remove the bolt (3) from the base
SEE MORE:
Oil filter: Removal - Refitting
K9K
WARNING
Always check the oil level using the dipstick.
Do not exceed the maximum level on the dipstick
(could destroy the engine).
Correct the engine oil level if necessary before
delivering the vehicle to the customer.
Note:
When topping up the engine oil, always leave at
least 10 minutes be
Oil-coolant heat exchanger: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine protector,
the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
the
© 2016-2026 Copyright Renault Clio Owners Club - 0.0074
