Renault Clio manuals
{MAINCONT}

Renault Clio: Fitting a radio

Renault Clio IV (2014-2019) Owners Manual / Practical advice / Fitting a radio

Radio location 1

Renault Clio. Radio location


Unclip the blanking cover. The aerial, + and – supply and speaker wire connections are located behind it.

Door speakers 2

Renault Clio. Door speakers


To install any equipment, please consult an authorised dealer.

  • In all cases, it is very important to follow the manufacturer’s instructions carefully.
  • The specifications of the brackets and wires (available from our network) vary depending on the equipment level of your vehicle and the type of radio.

    Consult an approved Dealer to find out the correct part number.

  • No work may be carried out on the vehicle’s electrical or radio circuits, except by approved dealers: an incorrectly connected system may result in damage being caused to the electrical equipment and/or the components connected to it.

READ NEXT:

 Accessories

Electrical and electronic accessoriesBefore installing this type of accessory (particularly for transmitters/receivers: frequency bandwidth, power level, position of the aerial, etc.

 Wipers (replacing blades)

Replacing windscreen wiper blades 1 With the ignition off, lift wiper arm 2; turn blade 1. Lower tab 3, by pressing on either side A. Then push the blade forwards B, to release

 Towing

Before towing, unlock the steering column: with the clutch depressed, engage first gear (lever in position N or R for vehicles with automatic gearboxes), insert the RENAULT card in the card reade

SEE MORE:

  Front seat: Stripping - Rebuilding

WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 1 IMPORTANT Before carrying out any work on a safety or proximity system component, lock the airbag computer using the Diagnostic tool. When this function is activated all the ignition lines are disabled and the airbag warning light on the instrument pan

  Rear Seat Frames And Mechanisms

Single unit rear bench seatback: Removal - Refitting REMOVAL I - REMOVAL PREPARATION OPERATION Remove the single unit rear bench seat base (see 76A, Rear seat frames and mechanisms, Single unit rear bench seat base: Removal - Refitting, 76A-6). II - OPERATION FOR REMOVAL OF PART CONCERNED R

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0036