Renault Clio: Trip computer and warning system
Information messages
These can help in the vehicle starting phase, or give information about a selection or a driving status.
Examples of information messages are given in the following pages.
|
Examples of messages |
Interpreting the display selected |
| « PARKING BRAKE ON » | Indicates that the parking brake has been applied |
| « PLEASE REMOVE KEYCARD » | Request to remove the RENAULT card from the reader when you leave the vehicle. |
| « TRACTION CONTROL OFF » | Indicates that you have deactivated the traction control function. |
| « TURN STEERINGWHEEL + START » | Turn the steering wheel slightly whilst pressing the vehicle start button to unlock the steering column. |
| « STEERING WHEEL NOT LOCKED » | Indicates that the steering column has not been locked. |
Operating fault messages
These appear with the 
warning
light and mean that you should drive very carefully to an authorised dealer as
soon as possible. If you fail to follow this recommendation, you risk damaging
your vehicle.
They disappear when the display selection key is pressed or after several
seconds and are stored in the computer log. The
warning light stays on. Examples of
operating fault messages are given in the following pages.
|
Examples of messages |
Interpreting the display selected |
| « CLEAN DIESEL FILTER » | Indicates the presence of water in the diesel filter; contact an approved Dealer as soon as possible. |
| « CHECK VEHICLE » | Indicates a fault in one of the pedal sensors, battery management system or oil level sensor. |
| « CHECK AIRBAG » | Indicates a fault in the restraint system in addition to the seat belts. In the event of an accident, it is possible that they may not be triggered. |
| « CHECK ANTI-POLLUTION SYSTEM » | Indicates a fault in the vehicle’s particle filter system. |
Warning message
These appear with the 
warning
light and require you to stop immediately, for your own safety, as soon as
traffic
conditions allow. Stop your engine and do not restart it. Contact an approved
Dealer.
Examples of warning messages are given in the following pages. Note: the messages appear on the display either individually or alternately (when there are several messages to be displayed), and may be accompanied by a warning light and/or a beep.
|
Examples of messages |
Interpreting the display selected |
| « ENGINE FAILURE HAZARD » | Indicates an injection fault, the vehicle’s engine has overheated or there is a serious engine fault. |
| « BRAKING SYSTEM FAULT » | Indicates a fault in the braking system. |
| « BATTERY CHARGING FAULT » | Indicates a fault in the vehicle battery charging circuit (alternator etc.). |
| « PUNCTURE » | Indicates that at least one wheel is punctured or severely underinflated. |
READ NEXT:
Display A
To access display 1 for setting the time,
press button 2 or 3. Wait for a few seconds.
The hours and minutes flash and you
are now in setting mode; press and
hold button 2 or 3 to set the ho
Display B
Vehicles fitted with touch-screen
multimedia, navigation aid systems,
telephones, etc.
Refer to the separate instructions for
the function to understand the special
features of this equipme
SEE MORE:
Automatic gearbox converter: Removal - Refitting
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front left-hand wheel arch liner (see
Front wheel arch liner: Removal - Refitting) (MR
393, 55A, Exterior protection).
Remove the resonator on the battery.
Disconnect the battery (see ) (MR 392, 80A, Battery).
II - OPERATION FOR REMOVAL
Driveshaft: Precautions for the repair
DP0 or JH3 or JR5 or TL4
WARNING
A gearbox oil leak at the driveshaft may destroy it.
WARNING
Always replace seals whenever the driveshaft is
removed.
WARNING
Grease the base of the bearing using BR 2 +
grease to prevent the bearing from sticking.
Make sure that the O-ring is correctly positioned i
