Renault Clio: Centre front panel: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Mechanisms And Accessories / Interior Equipment / Centre front panel: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the centre console (see 57A, Interior equipment, Centre console: Removal - Refitting, 57A- 14),
- the radio and/or the navigation system (see Radio: Removal - Refitting) (MR 392, 86A, Radio) or (see Radio navigation: Removal - Refitting) (MR 392, 83C, On-Board Telematics System).
- Unclip the lower trim (1) and (2).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the centre front panel (3) and (4).
- Disconnect the connectors.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Connect the connectors.
- Clip in the centre front panel.
II - FINAL OPERATION.
- Refit:
- the lower trim,
- the radio and/or the navigation system (see Radio: Removal - Refitting) (MR 392, 86A, Radio) or (see Radio navigation: Removal - Refitting) (MR 392, 83C, On-Board Telematics System),
- the centre console (see 57A, Interior equipment, Centre console: Removal - Refitting, 57A- 14).
READ NEXT:
Interior rear-view mirror: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip:
the upper cover,
the lower cover.
Note:
When removing the rear view mirror, be careful
not to damage the rain sensor nearby.
Disc
Dashboard cover gaiter: Removal - Refitting
IMPORTANT
Before carrying out any work on or near a safety
system component, lock the airbag computer
using the Diagnostic tool. When this function is
activated, all the trigger lines are disabled an
Safety Accessories
Front seat belt: Removal - Refitting
IMPORTANT
To avoid any risk of triggering when working on or
near a pyrotechnic component (airbags or pretensioners),
lock the airbag computer using the diagnosti
SEE MORE:
Rigid brake pipe: Removal - Refitting
The pipes have a rigid section and a flexible section.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Fit the pedal press to the brake pedal to limit the
outflow of brake fluid.
Raise the li
Shock absorber: Removal - Refitting
WARNING
To prevent any damage, do not use the rear axle as
support for the lifting system.
WARNING
To prevent any suspension asymmetry, replace
both of the shock absorbers on the same axle.
WARNING
To prevent the components of the rear axle from
deteriorating (rubber bushes, brake hoses, etc.) do
n
© 2016-2026 Copyright Renault Clio Owners Club - 0.0048
