Renault Clio: High level brake light bulb: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Rear Lighting / High level brake light bulb: Removal - Refitting
K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the tailgate spoiler (see Tailgate spoiler: Removal - Refitting),
- the high level brake light (see 81A, Rear lighting, 3rd brake light: Removal - Refitting, 81A- 10).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove:
- the bulb holder by pressing on the clips (1),
- the bulbs.
Note: When replacing bulbs, use approved W5W bulbs.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Clip:
- the bulbs into the bulb holder,
- the bulb holder onto the high-level brake light.
II - FINAL OPERATION.
- Refit:
- the high level brake light (see 81A, Rear lighting, 3rd brake light: Removal - Refitting, 81A- 10),
- the tailgate spoiler (see Tailgate spoiler: Removal - Refitting).
B85 or C85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the high level brake light (see 81A, Rear lighting, 3rd brake light: Removal - Refitting, 81A-10).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the bulb (1) from the bulb holder.
Note: When replacing the bulb, use an approved W16W bulb.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the bulb in the bulb holder.
II - FINAL OPERATION.
- Refit the high level brake light (see 81A, Rear lighting, 3rd brake light: Removal - Refitting, 81A-10).
READ NEXT:
Rear fog lights: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1
Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2
Interior Lighting
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a cou
Fuses
Fuses: List and location of components
Passenger compartment fuse and
relay box
Consumer cut-out fuse
Additional relay/fuse box
Battery protection fuses
Protection and switching unit
Power sup
SEE MORE:
Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
Shift the selector lever to third gear.
Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
Use a strap (2) to immobilise the lever against the
shim
Master cylinder: Removal - Refitting
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR
© 2016-2026 Copyright Renault Clio Owners Club - 0.0152
