Renault Clio: Speed sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Automatic Gearbox / Speed sensor: Removal - Refitting

DP0

Do not drain or remove the automatic gearbox in order to remove the speed sensor.

The output speed sensor has been deleted and replaced with wheel speed sensors.

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
• Disconnect the battery (see ) (MR 392, 80A, Battery).
• Remove:
  • the front left-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres),
  • the front left-hand wheel arch liner (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection,
  • the battery tray (see ) (MR 392, 80A, Battery),
  • the air filter unit (see Air filter unit: Removal - Refitting) (MR 392, 12A, Fuel mixture).

• Disconnect the modular connector (1) by pulling the sliding latch (2).

II - REMOVAL OPERATION FOR THE PART CONCERNED

• Disconnect the gearbox connector (3) by pulling the sliding latch (4).
• Remove the gearbox connector mounting bolts (5) from the support plate.

• Extract the yellow connector (3-track) (6) from the gearbox connector.
• Release the speed sensor wiring harness from the automatic transmission wiring duct.

• Remove: - the speed sensor mounting bolt, - the speed sensor (7).

WARNING

Protect the connector by sliding it into a waterproof plastic bag.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit the speed sensor.
• Torque tighten the speed sensor mounting bolt (10 Nm) ).
• Connect the green connector (3-track) of the gearbox connector.

II - FINAL OPERATION

• Refit the gearbox connector mounting board mounting bolts.
• Torque tighten the gearbox connector mounting bolts (20 Nm).
• Connect
  • the gearbox connector by pushing in the slide,
  • the modular connector by pushing in the slide.
• refit:
  • the air filter unit (see Air filter unit: Removal - Refitting) (MR 392, 12A, Fuel mixture),
  • the battery tray (see ) (MR 392, 80A, Battery),
  • the front left-hand wheel arch liner (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection,
  • the front left-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres).
• Connect the battery (see ) (MR 392, 80A, Battery).
• Check the gearbox oil level (see 23A, Automatic gearbox, Automatic gearbox oil: Draining - Filling, 23A-2).

READ NEXT: