Renault Clio: Suspended engine mounting: Tightening torque
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine Mounting / Suspended engine mounting: Tightening torque
D4F
Tightening torque (in Nm)
K4J, and JH3
K4M, and JH3
K4M, and DP0
K9K, and JR5
K9K, and JH3
K9K, and TL4
D4F, and JH3
M4R, and DP0
F4R
M4R, and TL4
READ NEXT:
Lower engine tie-bar: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (see Battery: Remov
Right-hand suspended engine mounting: Removal - Refitting
D4F or K9K, and JH3
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see ) (MR 392, 80A, Battery).
Remove:
the scuttle panel grille (see Scuttle panel grille:
Removal - Refitt
Left-hand suspended engine mounting: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (MR 393, 56A, Exterior
equipment),
the scoop under th
SEE MORE:
Front centre air distribution duct: Removal -
Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components
(MR 394, 88C, Airbags and pretensioners).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the driver's front
Tyre pressure: Identification
I - INFLATION
WARNING
If checking the tyre pressure when hot, increase the
recommended pressure by 0.2 to 0.3 bar.
B85 or C85 or S85
The pressure values given are recommendations when
cold.
K85
II - CONFORMITY CHECK AND ADJUSTMENT
If the tyre size is changed, calibrate the electric power-assisted
© 2016-2025 Copyright Renault Clio Owners Club
