Renault Clio: Sequential gearbox oil: Specifications

5-SPEED MANUAL SEQUENTIAL GEARBOX

I - GEARBOX TYPE/OIL TYPE CORRELATIONS:

II - STANDARDS AND PART NUMBERS OF THE VARIOUS RECOMMENDED OILS:

Sequential gearbox: Bleeding

I - PROCEDURE

WARNING

• Even a tiny air bubble can cause a malfunction.
• Incorrect bleeding may cause fault finding errors and lead to an unnecessary part replacement.

II - GEARBOX REMOVED

WARNING

When removing the hydraulic clutch tappet, fill the tappet with an approved fluid (see 21B, Sequential gearbox, Sequential gearbox oil: Specifications, 21B-82) before refitting the gearbox, following the procedure described below.

• Fill the reservoir (1) with approved clutch circuit fluid.
• Activate the clutch tappet manually (releasing/engaging the clutch) until releasing/engaging the clutch becomes very difficult, without releasing any air bubbles. If necessary use the fluid (DOT4) to fill the reservoir.

III - GEARBOX IN POSITION

• Drain the reservoir of approved clutch circuit fluid.
• Remove the bleed screw cap.
• Connect a transparent tube to the bleed screw, connected to a syringe with an effective volume of 60 cm3 filled with approved fluid.
• Push the clutch pipe retaining clip and pull the pipe so that it is in the bleed position.
• Slowly inject the fluid in the syringe, making sure that the fluid does not overflow out of the reservoir.
• Carry out the Intake - Reflux operations slowly using the syringe until all of the air bubbles have disappeared.
• Push the pipe back into the retaining clip.
• Perform an auto-bleed using the Diagnostic tool.
• Check that the system is operating correctly by carrying out a road test.
• The level is correct when the fluid is halfway up the reservoir.

Electro-hydraulic unit: List and location of components

D4F, and JA3

1. Clutch solenoid valve
2. Gear engagement solenoid valve
3. Gear engagement solenoid valve
4. Selection solenoid valve
5. Engagement sensor
6. Gear selection sensor
7. Solenoid valve unit pressure sensor
8. High pressure filter

K9K, and JA5

1. Clutch solenoid valve
2. Gear engagement solenoid valve
3. Gear engagement solenoid valve
4. Selection solenoid valve
5. Engagement sensor
6. Gear selection sensor
7. Solenoid valve unit pressure sensor
8. High-pressure filter

READ NEXT: