Renault Clio: Front side door protective strip: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Unclip the blanking cover (1).
- Remove the bolt.
- Remove the side mounted indicator (2) using a small flat screwdriver.
- Disconnect the power supply connector.
II - REMOVAL OPERATION FOR PART CONCERNED
- Slide the door rubbing strip towards the rear of the vehicle.
III - REFITTING OPERATION FOR PART CONCERNED
- Slide the door moulding towards the front of the vehicle.
IV - FINAL OPERATION.
- Refit:
- the protective strip mounting bolt,
- the blanking cover,
- the mounted indicator.
Rear side door protective strip: Removal - Refitting
B85 or K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Strip off the adhesive (1).
- Remove the bolt.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Slide the door moulding towards the front of the vehicle.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Slide the door moulding towards rear of the vehicle.
II - FINAL OPERATION.
- Refit:
- the protective strip mounting bolt,
- the adhesives (Part no: 77 01 465 890).
C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the rear wing protective strip (1).
REFITTING
I - REFITTING PREPARATION OPERATION
- Check the condition of the clips and replace them if necessary.
II - REFITTING OPERATION FOR PART CONCERNED
- Clip on the rear wing protective strip.
Roof protection strip: Removal - Refitting
C85 or S85
REMOVAL
Note: It is possible to replace the access flap for mounting the roof rack bars.
OPERATION FOR REMOVAL OF PART CONCERNED
- Carefully unclip the roof protection strip.
REFITTING
I - REMOVAL PREPARATION OPERATION
- Check the condition of the clips (1) and replace if necessary.
II - FINAL OPERATION.
- Clip the roof protection strip in position.
READ NEXT:
Front wheel arch liner: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove the front wheel (see Wheel: Removal - R
Rear bumper: Stripping - Rebuilding
B85 or C85 or S85, and EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or
EQUIPMENT LEVEL EA3 or
EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1
STRIPPING
I - STRIPPING PREPARATION O
SEE MORE:
Opening and closing the doors
Opening the doors from the outside
Front doors
With the doors unlocked, pull handle 1.
Special feature of the RENAULT
“hands-free” card
With the doors locked, press button 2
on handle 1 of one of the two front
doors and pull towards you.
Rear doors
With the doors unlocked, pull hand
Locking, unlocking the opening elements
Locking/Unlocking the doors
from the outside
This is done using the RENAULT Card;
see the “RENAULT Card” information in
Section 1.
In certain cases, the RENAULT card
may not work:
if the RENAULT card battery is weak,
flat, etc.
if equipment operating on the same
frequency as the ca
