Renault Clio: Rear drum bearing: Removal - Refitting

Using a dial gauge connected to the drum, check that the end float is greater than 0.03 mm.

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
• Remove:
  • the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1),
  • the brake drum (see 33A, Rear axle components, Rear brake drum: Removal - Refitting, 33A-19).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• From the drum, remove:
  • the bearing retaining circlip (1),
  • the bearing (2) using a tube with an external diameter of 47 mm and a press.

Note: Check that the tube is pressing against the outer bush of the bearing.

REFITTING

I - REMOVAL PREPARATION OPERATION

• Clean:
  • the internal and external surfaces of the new bearing in contact with the drum and the stub axle,
  • the surfaces of the drum in contact with the new bearing,
  • the stub-axle surfaces in contact with the new bearing,

WARNING

It is essential to check the condition of the surface of the stub axle and the bore of the drum before refitting the bearing. Replace the stub axle carrier if it is faulty.

WARNING

Do not apply pressure to the inner bearing bush, to avoid damaging the bearing (significant force is required for fitting).

II - REFITTING OPERATION FOR PART CONCERNED

• Lift the bearing until it presses onto the shoulder using a tube with an external diameter of 51 mm and a press.
• Refit the circlip

III - FINAL OPERATION

• Refit:
  • the brake drum (see 33A, Rear axle components, Rear brake drum: Removal - Refitting, 33A-19),
  • the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).

READ NEXT: