Renault Clio: Pressure sensor: Removal - Refitting

AIR CONDITIONING or CLIMATE CONTROL

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
• Remove:
  • the front wheels (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres),
  • the front wheel arch liners (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection),
  • the front bumper (see Front bumper: Removal - Refitting) (MR 393, 55A, Exterior protection).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Disconnect the pressure sensor connector (1).

Note: An automatic shut-off valve isolates the circuit from the outside during removal; do not drain the refrigerant from the circuit.

• Remove the pressure sensor.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit the pressure sensor.
• Tighten the pressure sensor.
• Connect the pressure sensor connector (2).

II - FINAL OPERATION.

• Refit:
  • the front bumper (see Front bumper: Removal - Refitting) (MR 393, 55A, Exterior protection),
  • the front wheel arch liners (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection),
  • the front wheels (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres),

READ NEXT: